HYS=DISABLE_, FUNC=SELECTS_FUNCTION_PIO, MODE=INACTIVE_NO_PULL_DO, OD=STANDARD_GPIO_OUTPUT
I/O configuration for pin PIO2_11/SCK0
| FUNC | Selects pin function. All other values are reserved. 0 (SELECTS_FUNCTION_PIO): Selects function PIO2_11. 1 (SELECT_FUNCTION_SCK0): Select function SCK0 (only if pin PIO2_11/SCK0 selected in Table 98). |
| MODE | Selects function mode (on-chip pull-up/pull-down resistor control). 0 (INACTIVE_NO_PULL_DO): Inactive (no pull-down/pull-up resistor enabled). 1 (PULL_DOWN_RESISTOR_E): Pull-down resistor enabled. 2 (PULL_UP_RESISTOR_ENA): Pull-up resistor enabled. 3 (REPEATER_MODE_): Repeater mode. |
| HYS | Hysteresis. 0 (DISABLE_): Disable. 1 (ENABLE_): Enable. |
| RESERVED | Reserved |
| OD | Selects pseudo open-drain mode. See Section 7.1 for part specific details. 0 (STANDARD_GPIO_OUTPUT): Standard GPIO output 1 (OPEN_DRAIN_OUTPUT): Open-drain output |
| RESERVED | Reserved |